Kistler-morse KM STXPlus Manuel d'utilisateur télécharger pdf (Page 52)

APPENDIX B: KISTLER-MORSE

PROTOCOL SERIAL COMMANDS

Request from Master Response from STXplus

>aaLD0000dddssr Ar Format

>01LD1254r Ar Example

‘RW’ Command — Read DSP Step Monitor Value

This command is sent by the master to request the STXplus to send the DSP step monitor value.

The range of this value can be between 0 and 2,147,483,647. For this example, the master

requests DSP step monitor value for an STXplus at address 01 assuming it is using a format of

4(X.XX), which returns 347.51 engineering units and a checksum of 32.

Request from Master Response from STXplus

>aaRWnssr A(-)ffffffffssr Format

>01RW0Ar A347.5132r Example

‘wW’ Command — Write DSP Step Monitor On/Off

This command is sent by the master to set the state of the DSP Step Monitor of an STXplus.

The range of acceptable values is 0-1 where 0 for Off or 1 or On with a reseting of the DSP step

monitor value. For this example, the master requests DSP step monitor state for an STXplus at

address 01 to 1 (On), which returns a checksum of 32.

Request from Master Response from STXplus

>aawWnssr Ar Format

>01wW60r Ar Example

‘e1’ Command — Read Serial Port 1 Baud Rate

This command is sent by the master to request the STXplus to send serial port 1’s baud rate. The

range of acceptable values is 0-3 where 0 for 9600K, 1 for 19.2K, 2 for 38.4K, or 3 for 115.2K.

The default value is 0 (9600). For this example, the master requests serial port 1’s baud rate for

an STXplus at address 01 which returns 0 (9600) and a checksum of 50.

Request from Master Response from STXplus

>aae1ssr A000000dssr Format

>01e1F7r A000000050r Example

‘g1’ Command — Write Serial Port 1 Baud Rate

This command is sent by the master to set the serial port 1’s baud rate of an STXplus. The range

of acceptable values is 0-3 where 0 for 9600K, 1 for 19.2K, 2 for 38.4K, or 3 for 115.2K. For this

example, the master sets serial port 1’s baud rate for an STXplus at address 01 to 1 (19.2K). Any

of the 6 leading zeros may be omitted.

Request from Master Response from STXplus

>aag1000000dssr Ar Format

>01g112Ar Ar Example

B-33

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 75 76

Pas de commentaire

Kistler-morse KM STXPlus Manuel d'utilisateur Page 52